To access the switch remotely, an IP address and a subnet
mask must be configured on the SVI. To configure an SVI on a switch, use
the interface vlan 1 global configuration command. Vlan 1 is not
an actual physical interface but a virtual one. Next assign an IPv4
address using the ip address ip-address subnet-mask interface configuration command. Finally, enable the virtual interface using the no shutdown interface configuration command.
After these commands are configured, the switch has all the IPv4 elements ready for communication over the network.
Click Play in the figure to view a video demonstration of how to configure a switch virtual interface.
Click here to read the transcript of this video.
After these commands are configured, the switch has all the IPv4 elements ready for communication over the network.
Click Play in the figure to view a video demonstration of how to configure a switch virtual interface.
Click here to read the transcript of this video.
0 comments:
Post a Comment